Toro TimeCutter MX4275 Operator's Manual page 11

Key Switch
The key switch, used to start and shut off the engine,
has 3 positions: O , R
FF
Refer to Starting the Engine (page
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position (Figure 5).
Choke Control
Use the choke control to start a cold engine
Blade-Control Switch (Power
Takeoff)
The blade-control switch, represented by a
power-takeoff (PTO) symbol, engages and
disengages power to the mower blades
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
Park Position
Move the motion-control levers outward from the
center to the P position when exiting the machine
ARK
to engage the electric brake
position the motion-control levers into the P
position when you stop the machine or leave it
unattended.
MyRide™ Adjustment Lever
Use the MyRide™adjustment lever to adjust the seat
suspension (Figure 4).
Smart Speed™ Control System
Lever
The Smart Speed™ Control-System lever, located
below the operating position, gives you a choice to
drive the machine at 3 speed ranges— trim, tow, and
mow (Figure 23).
Fuel-Presence Window
You can use the fuel window, located on the left side
of the machine, to verify the presence of fuel in the
tank (Figure 6).
, and S (Figure
UN TART
19).
to F
LOW
(Figure
(Figure
(Figure
(Figure 20). Always
ARK
5).
AST
5).
1. Fuel-presence window
Height-of-Cut Lever
5).
Use the height-of-cut lever to lower and raise the deck
from the seated position. Moving the lever up (toward
you) raises the deck from the ground and moving the
lever down (away from you) lowers the deck toward
the ground. Adjust the height-of-cut only while the
machine is not moving
4).
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
11
Figure 6
(Figure 24).
g292100