Level The Range; Final Installation Check List - Hisense HBG3601CPS Instructions For Installation Manual

Level the range

WARNING!
Never completely remove the leveling leg as the range will not be secured to the anti-tip
device properly.

Final installation check list

• Check to make sure the circuit breaker is closed or the circuit fuses are replaced.
• Be sure power is in service to the building.
• Check that all packaging materials and tape have been removed. This will include tape on the
metal panel under control knobs (if applicable), adhesive tape, wire ties, cardboard and protective
plastic. Failure to remove these materials could result in damage to the appliance once the appliance
has been turned on and surfaces have heated.
• Check that the door and drawer are parallel to each other and that both operate smoothly. If they
do not, see the User Manuals for proper replacement.
• Check to make sure that the rear leveling leg is fully inserted into the Anti-Tip bracket.
Operation checklist
• Make sure the combustion and ventilation airflow to the range is unobstructed.
• Be sure all range controls are in the OFF position before leaving the range.
• Install the oven shelves in the oven and
position the range where they will be
installed.
• Check for levelness by placing a spirit level
on one of the oven shelves. Take two
readings, with the level placed diagonally
first in one direction and then the other.
• First, remove the drawer.
• Level the range by adjusting the leveling
legs with a wrench.
• The front leveling legs can be adjusted from
the top or the bottom leg (1).
• The rear legs can be adjusted from the top
of the leg (2) through the drawer opening.
EN 13