Barcode Reading Length; Code 93; On/Off - Waveshare Barcode Scanner Module B Setup Manual

When "Check Character" is set to "Enable with check character transmission", the device will check
according to the last digit data of the barcode. If the check passes, the check character will be
transmitted as the last digit of normal data. If the check fails, the barcode content will not be sent.
* No Check Character Enabled Without Check
Characters Transmission
Enable with Check Characters
Transmission

BARCODE READING LENGTH

Scan the following barcode to change the reading length. For additional information, please refer
to the code length description. The minimum and maximum length is 2-80. Minimum default value
=4, and maximum default value =80. (Note: After scanning "Minimum Barcode Length" and
"Maximum Barcode Length", you need to scan the specified barcode length and save the barcode.
Please refer to the Bardcode Reading Length instruction.)
Minimum Barcode Length Maximum Barcode Length

CODE 93

All Default Code 93 Settings

ON/OFF

* On Off
33 / 69