E&G Classics 1398-0502-09 Instruction Manual

IMPORTANT: PLEASE KEEP THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE !
Copyright © 2010 by E&G Classics, Inc. All right reserved. The reproduction or uti li za tion of this work in any form or any elec tron ic, me chan i cal, or other means, no known or here af ter in vent ed,
including xe rog ra phy, pho to copy ing, and re cord ing, and in any in for ma tion storage retrieval system is for bid den with out written per mis sion of owners.

TOOLS REQUIRED

E&G is proud to present this package to you and reminds you that for technical in for ma tion, contact Lynn Eash or Lee Clary at 410-381-4900. Do not at tempt the in stal la tion of any
E&G prod uct without first reading the detailed in struc tions. E&G Clas sics will not war rant dam aged parts or the ve hi cle due to altered in stal la tion in struc tions.
1. Open the hood and remove the plastic push fasteners retaining
the radiator support panel cover to the vehicle.
3
3. Remove the factory screws securing the top edge of the grille and
bumper cover to the mounting panel.
Copyright 2010 by E&G Classics, Inc.
2009-11 Chevrolet Traverse
Pro-Form Overlay Fine Mesh Grille
Part #: Complete 1398-0502-09
Long flat blade screwdriver, #2 Phillips screwdriver, 2 - 6" sections of 2x4 wood, vice grips or long nosed
pliers, automotive grade masking tape.
Notes to the Technician/Installer:
1
2
2. Remove the end of the factory weatherstrip attached to the radia-
tor support panel cover and reinstall the push pin back into the
weatherstrip if it comes out.
4a
4. Apply several layers of masking tape to the factory grille sur-
rounds to protect the finish.
4a. Align the lower Pro-Formed mesh section over the factory grille
and use masking tape to hold it in place while aligning and in-
stalling the mounting pins.
visit us online today at www.egclassics.com
B 07 H1 P
4