Advertisement
Table of Contents
Chrome Plated S. S. Fine Mesh Insert
(8) 8-32 ESNA Half Nuts
Top Mounting Plate
Lower Mesh Retainer w/Pins
BL ACK ICE S. S. Fine Mesh Insert
(8) #8-32 ESNA Half Nuts
Top Mounting Plate
Lower Mesh Retainer w/Pins
IMPORTANT!
The exposed edges of the stainless steel
grille and mesh can be extremely sharp.
Please handle with care.
A
1409-0034-10
1409-0020-10
1999-0065-00
1409-0210-10
1409-0042-10
B
1221-0158-09
1999-0065-00
1999-0264-00
1999-0311-00
3999-9035-00
Remove the factory upper grille from the bumper cover
1409-0039-10
by removing the threaded push pins across the top of the
1409-0158-10
grille
and the phillips screws located at the sides and
bottom of the grille
ratcheting screw driver works best (grille shown removed
to show screw locations).
1409-0034-10
1999-0065-00
1409-0210-10
1409-0042-10
1221-0158-09
1999-0065-00
1999-0264-00
1999-0311-00
3999-9035-00
1409-0039-10
1409-0158-10
. Cut out and align the supplied
lines on the
cover. Once properly aligned, tape the
and use an awl or similar pointed to the mark the hole
locations onto the bumper cover, then remove the
.
B
. A short phillips screwdriver or
4
, making sure the
match the openings in the bumper
into place
1
3
. Apply masking tape around the lower grille opening.
Advertisement
Table of Contents
Related Manuals for E&G Classics 1409-0102-10
Summary of Contents for E&G Classics 1409-0102-10
- Page 1 1409-0034-10 1409-0020-10 Chrome Plated S. S. Fine Mesh Insert 1999-0065-00 (8) 8-32 ESNA Half Nuts 1409-0210-10 Top Mounting Plate 1409-0042-10 Lower Mesh Retainer w/Pins 1221-0158-09 1999-0065-00 1999-0264-00 1999-0311-00 3999-9035-00 Remove the factory upper grille from the bumper cover 1409-0039-10 by removing the threaded push pins across the top of the 1409-0158-10 grille and the phillips screws located at the sides and...
- Page 2 . Use a .125 (1/8 ) drill bit to drill through the marks made . Trim the ends from the supplied Align the into the in the previous step, then use the drill bit to connect the and install them over the studs on the lower factory opening in the bumper cover and use holes making small mounting slots.
- Page 3 E&G GRILLES BILLET GRILLES...
Need help?
Do you have a question about the 1409-0102-10 and is the answer not in the manual?
Questions and answers