Craftsman CMXZSAJ93394 Instruction Manual page 5

Fig. B
9
Attaching the Foot Rest (Fig. C)
1. Turn the stool frame upside down. Take the foot rest
ring 11 and insert it inside of the legs. Line up the bolt
holes on the foot rest ring with the legs. Insert a ring
bolt - M6 x 41 mm 12
foot rest ring. Tighten by hand with a locking nut - M6.
Repeat for the remaining 3 legs (Fig C).
Fig. C
12
13
7
13
through the leg and into the
Attaching the Top Ring (Fig. D)
1. Turn the stool frame right side up. Place the top ring
10 over the legs and line up the bolt holes. Insert a
ring bolt - M6 x 41 mm through the top ring into the
leg. Tighten by hand with a locking nut - M6. Repeat
for the remaining three legs (Fig D).
2. Begin securing all bolts and nuts with the included
Fastener Combo Tool
avoid risk of over-tightening and/or stripping fasteners,
the use of power tools is not recommended. Start with
the foot rest ring, then secure the top ring, and finish
with the leg joining bracket. Ensure that the leg joining
plate conforms with the legs while the leg bolts - M6 x
40 mm are secured.
Fig. D
12
Attaching the Seat (Fig. E, F)
1. Insert the pneumatic cylinder
11
leg joining bracket. The strut must extend
upward (Fig E).
2. Place the cushion seat
lining up the round opening on the cushion seat with
the strut of the pneumatic cylinder. Firmly push down
on the cushion seat to fully engage the pneumatic
cylinder. At this time, inspect the cushion seat by
picking it up to ensure that is has fully engaged the
pneumatic cylinder (Fig F).
ENGLISH
15 and 10mm Wrench 16
5 into the center of the
4 onto the pneumatic cylinder
. To
10
13
5