Specifications - Panasonic ES-8163 Operating Instructions Manual

Wet/dry rechargeable shaver
Table of Contents

Advertisement

Available languages

Available languages

into the shaver.
ATTENTION:
A Lithium-ion battery that is recy-
clable powers the product you
have purchased. Please call 1-
800-8-BATTERY for information on
how to recycle the battery.
WARNING for Lithium Battery:
Fire, explosion, and severe burn
hazard.
Do not crush, disassemble, heat
above 100°C (212°F), or inciner-
ate.
How to remove the built-in
rechargeable battery before
disposal of the shaver
(see fig. 10)
The battery in this shaver is not in-
tended to be replaced by consum-
ers. However, the battery may be re-
placed at an authorized service
center. The procedure described be-
low is intended only for removal of
the rechargeable battery for the pur-
pose of proper disposal.
1. Remove the bottom cover screw
(a).
2. Remove the bottom cover (b).
3. Slide the back panel (c) and re-
move it.
4. Remove the housing clip (d).
5. Remove the four housing screws
(e).
6. Remove the housing B (f).
7. Lift the battery (g) and remove it.
WARNING:
Do not attempt to replace the bat-
tery for the purpose of reusing the
shaver. This could result in the risk
of fire or electric shock.
Caution – To prevent
personal injury or damage
to the product,
• Do not charge the shaver where the
temperature is below 15°C (41°F)
or above 35°C (95°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
• Use only the included adaptor
RE7-25 to charge the ES8163
shaver.
• Dry the shaver completely before
charging it.
• Keep the adaptor away from water
and handle it only with dry hands.
• Grip the adaptor when disconnect-
ing it from an AC outlet; tugging on
the power cord may damage it.
• Store the adaptor in a dry area
where it will be protected from dam-
age.
• Do not pull, twist, or severely bend
the power cord.
• Do not wrap the power cord tightly
around the appliance.
• In cases where static noise is emit-
ted from the television during use
or recharging connect the adaptor
to different outlet.
10
9
• The shaver and adaptor will be-
come slightly hot during use or
charging, however this is not a
malfunction.
• Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets, bath-
rooms or kitchen appliances. Do
not submerge the shaver for a long
time.
• Do not wipe any part of the shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
• Do not take the housing apart as
this can affect the watertight con-
struction.
• Do not clean with water when the
shaver is connected to the power
cord.
• Do not shave when the "sonic" vi-
bration is activated, as it may dam-
age your skin.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN
USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT
1-800-338-0552.
• When cleaning the shaver with
water, do so with both the inner
blades attached. (Doing so with
only one of the inner blades at-
tached makes an abnormal noise
and may damage the shaver.)
• This charging stand is intended to
be correctly orientated in a vertical
on floor mount position.

Specifications

Power source: 100-240V AC,
50-60 Hz (Automatic voltage conver-
sion)
Motor voltage: 3.6 V DC
Charging time: 1 Hour
This product is intended for house-
hold use only.
11
10

Advertisement

Table of Contents
loading

Table of Contents