Epson Solar Series Instructions page 3

 Guidelines for charging time
The below table provides only general guidelines.
Illumination
Source of light
(Lx)
700
A fluorescent lamp
3,000
10,000
Sunlight
100,000
Condition A : Time required for full charge
Condition B : Time required for steady operation
Condition C : Time required for 1 day's charge
(*) The values in this column represent the charging times required until the second hand moves constantly at one-second intervals
after the watch starts operating with the second hand moving at two-second intervals.
Even if the watch is not charged for the time specified in the column, the second hand may temporarily move at one-
second intervals. But it will soon resume moving at two-second intervals; therefore, charge the watch for more than the
specified period.
 How to use stopwatch function
• The stopwatch can measure up to 9'59'' in one-second increments.
• When the measurement reaches 10 minutes, the stopwatch automatically stops counting and the stopwatch
hands return to the "0" position.
 Standard measurement
Button A
Start
 Accumulated elapsed time measurement
Button A
Start
 Split time measurement
Button A
Start
 Measurement of two competitors
Button A
Start
• The stopwatch second hand is capable of timing 10 minutes. (60 seconds x 10 times)
• The stopwatch minute hand is capable of timing 10 minutes.
• Before using the stopwatch, be sure to check that the crown is set at the normal position and that the
stopwatch hands are reset to the "0" position.
- If the stopwatch hands do not return to the "0" position when the stopwatch is reset to "0", follow the procedure in
"Stopwatch hand position adjustment".
Environment
Inside the office
30W 20cm
Cloudy
Fine weather
Button A
Stop
Button A
Stop
Button B
Split Split release
Measurement and release of sprit time
can be repeated by pressing the button B.
Button B
Finish time 2nd competitor
of 1st competitor finishes
A
(Approx. Hours)
－
52
16
5.3
Button B
Reset
Button A Button A
Restart
Restart and stop of the stopwatch can
be repeated by pressing the button A.
Button B Button A
Button A Button B
Finish time
of 2nd competitor
(Dial transparency rate is 30%)
B (*)
(Approx. Hours) (Approx. Minutes)
18 69
4 15
1.5
0.5
Button B
Stop
Button B
Stop
Button B
C
5
2
Reset
Reset
Reset