ENGLISH en Original operating instructions c) Adjust the cutting depth to the thickness of 1. Declaration of Conformity the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece. We hereby declare under our sole responsibility d) Never hold the workpiece in your hands or that these cordless hand-held circular saws, across your leg while cutting.
Page 6
ENGLISH teeth are not engaged into the material. If a saw Press the spindle locking button only when the blade binds, it may walk up or kickback from the motor is at a standstill. workpiece as the saw is restarted. Do not reduce the speed of the saw blade by d) Support large panels to minimise the risk of pressing on the sides.
Instructions on charging the battery pack can be Use suitable accessories for special work. In this found in the operating instructions of the Metabo way, fewer particles enter the environment in an charger. uncontrolled manner.
ENGLISH blade juts out under the workpiece. See illustration Chapter 4...Kickback... in addition to all other on page 3. safety instructions). Try to prevent the machine from seizing. Slanting saw blade for diagonal cuts Switching on and off Loosen the locking screws (1). Tilt the motor part against the guide plate (15).
According to European Directive 2012/19/EU on Waste from Electric and Electronic Equipment Use only genuine Metabo - saw blades. Saw and implementation in national law, used power blades intended for cutting wood or similar tools must be collected separately and recycled in materials have to conform to EN 847-1.
Page 10
ENGLISH = maximum depth of cut = adjustable depth of cut (90°) 90° = adjustable depth of cut (45°) 45° = adjustable angular cut angle Ø = saw blade diameter = saw blade drill diameter = max. base body thickness of the saw blade = max.
Need help?
Do you have a question about the KS 18 LTX 57 and is the answer not in the manual?
Questions and answers