Table of Contents
Advertisement
Chapter 02
Preparations
Installation
Attaching the Stand
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
4
5
4
Place the protective Styrofoam
Hold the main body of the product
(cushion) included in the package on
with your hand as shown by the figure.
the floor and place the product facing
Push the assembled stand into the
down on the Styrofoam, as shown in
main body in the direction of the
the image. If Styrofoam is unavailable,
arrow as shown in the figure.
use a thick sitting mat.
1
2
Insert the stand neck into the stand
Turn the stand neck 180° into normal
base in the direction shown in the
position.
figure.
6
Connect the power supply and the
Caution
signal cable as shown in the figure.
Do not arbitrarily remove the panel
film. If not observed, the warranty
service may be restricted.
3
3
Align the stand with the stand neck
guide and then turn the screw on the
bottom of the stand to fix the stand.
9
Hide quick links:
Advertisement
Table of Contents
