Preparations
Installation
Attaching the Stand
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing
"
downwards.
Disassembly is the reverse order of assembly.
"
S27DM50* S32DM50* S32DM70*
1
Put the stand base onto the stand neck
as the direction shown in the figure.
Check that the stand neck is firmly
connected.
4
3
Push the assembled stand into the main body in the direction of the arrow as
shown in the figure. Tightly fasten the connecting screw at the bottom of the main
body.
Caution
Do not arbitrarily remove the panel film. If not observed, the warranty service may be restricted.
x 2
2
Tightly fasten the connecting screw at
the bottom of the stand base. Fasten
the large screw in the middle for
assembly.
- 7 -
3
As shown in the figure, remove the
product and foam cushion, and then
place the product on the table with its
front side facing the floor.
5
4
Stand assembly is complete.