Chapter 02
Preparations
Installation
Attaching the Stand
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
― Disassembly is the reverse order of assembly.
3
Push the assembled stand into the main body in the direction of the
arrow as shown in the figure.
1
Put the stand base onto the stand neck
as the direction shown in the figure.
Check that the stand neck is firmly
connected.
4
Stand up the monitor as shown in the
figure.
2
Tightly fasten the connecting screw at
the bottom of the stand base. Fasten the
large screw in the middle for assembly.
5
After installing the stand, place the
product upright.
Caution
Do not arbitrarily remove the panel film.
If not observed, the warranty service may
be restricted.
9