Inova IDESK 61 User Manual page 22

Control Panel Operation and Programming Instructions
1. Make sure all components are connected correctly ( control box, control panel, power cable
and connecting cable, lifting columns).
2. Connect the power cable to a 110/240VAC outlet. After the control panel will display ''61.0''
sign for a few seconds, the system is turn on and the desk is ready for use.
3. Up and Down
Press and hold the ''UP'' button to move up the desk to tge desired height. The desk will stop
when the button is released. Press and hold the ''DOWN '' button to lower the desk to the
desired height. The desk will stop when the button is released.
4. Memory Settings
After adjusting the desk height usine the ''UP'' / ''DOWN'' buttons, press the ''M'' button and
''S - ''sign will be displayed on the control panel. Then press the desired button from 1 to 4 to
assign the current height to a number on the keypad. Can be saved and memorized 4 different
heights. Moving the desk to a preset height can be done by pressing the corresponding button
from 1 to 3. During operation you can stop the desk by pressing one of the ''UP''/''DOWN''
buttons.
5. Keypad locks
To lock : Press and hold ''UP'' and ''DOWN'' buttons for 5 seconds until ''LOC'' sign appears on
the display, indicating that the system is locked. To unlock : Press the ''UP and ''DOWN'' buttons
for 5 seconds at a same time until the ''LOC'' sign disappears and the height of the desk is
displayed, indicating that the system is ready to be adjusted again.
6. Reset (RES)
When the system is experiencing a problem or the control panel display ''RES'', the system must
be reset. Press and hold the ''DOWN'' button throughout the process. After 5 seconds, the
desk will lower slightly until it reaches its lowest height, then rises slightly and the display
changes back to the numeric height setting. After the desk stops, the reset process is
successfully completed.
-7-