Mounting Wallplate To Wall - Honeywell T8002 Installation Instructions Manual

T8002 PROGRAMMABLE THERMOSTAT
NO

Mounting Wallplate to Wall

IMPORTANT
Level only for appearance. The thermostat func-
tions normally even when not level.
Mount the wallplate to the wall with the screws provided
(see Fig. 2) as follows:
1. Place the wallplate at the desired location on the
wall.
2. Pull the thermostat wire through the wallplate
entrance hole.
3. Fasten the wallplate to the wall using the anchors
and screws provided.
4. After wiring the wallplate, plug the hole with non-
flammable insulation to prevent drafts from affect-
ing the thermostat.
WALL
1
MOUNTING
SCREWS (2)
1 WHEN USING WALL ANCHORS, DRILL 3/16 INCH
HOLES FOR DRYWALL, 7/32 INCH HOLES FOR
PLASTER OR WOOD.
Fig. 2. Mounting wallplate to wall.
69-1549
NO
Fig. 1. Selecting typical thermostat location.
WALL
ANCHORS (2)
WALLPLATE
M12202A
YES
NO
5 FEET
[1.5 METERS]
Wiring
IMPORTANT
Use an 18-gauge maximum wire to wire the
thermostat.
All wiring must comply with local electrical codes and
ordinances. Disconnect the power supply to prevent
electrical shock or equipment damage.
The shape of the terminals allows inserting straight or
wraparound wiring connections; either method is
acceptable. A letter code is located near each terminal
for identification. See Fig. 3.
NOTE: To ensure accurately mounting the thermostat,
restrict all wiring to the shaded area in the cen-
ter of the terminals. See Fig. 4.
2
M11338