Finding Your Password (Date Code) To Access Installer Options; Mounting Thermostat On Wallplate - Honeywell VISIONPRO 8000 Installation Manual

CONVENTIONAL
C
K
RC
R
U1
U1
U2
U2
HEAT PUMP
Fig. 13. Thermostat wired directly to equipment.
1. Power the thermostat using Rc and C terminals. Refer
to Fig. 14.
CONVENTIONAL
C
K
RC
R
U1
U1
U2
U2
HEAT PUMP
Fig. 14. Inserting wires in thermostat terminal block.

Mounting Thermostat on Wallplate

1. If your thermostat has hinges along the bottom and a
button on the top, align the thermostat at the bottom
and snap into place as shown. If you have the
updated model without hinges, line the thermostat
up evenly with the wallplate and push the thermostat
evenly along the sides and bottom to snap it into
place.
Fig. 15. Mount thermostat.
S1 S1
S1 S1
W O/B
Y Y
G G
AUX
W2
-E
Y2
Y2
A
L/A
S1 S1
S1 S1
W O/B
Y Y
G G
W2 AUX
-E
Y2
Y2
A
L/A
9
VISIONPRO® 8000 SMART THERMOSTAT
Finding Your Password (Date Code)
to Access Installer Options
You need a password (Date Code) to access Installer
Options. Installer Options allow you to:
• Make changes to the Installer Setup.
• Perform an Installer Test.
• Reset the thermostat to Factory Default settings.
The password (Date Code) is located on the back of the
thermostat. It can also be found by following these steps:
1. Touch Menu.
2. Select Dealer Information.
Dealer Information
Installer Options
Fig. 16.
3. Scroll down to see the Date Code.
TH8321WF1001
Date Code:
Fig. 17.
MCR34022
1524
MCR35348
33-00096—05