Remote Control Panel - Hitachi RAW-XH07CA Installation & Operation Manual

Operation procedure

Remote control panel

Note: If wireless remote control is lost, you can use the remote control panel and operate manually.
2
3
7
1 ON/OFF BUTTON
Operation starts when pressing this button. Pressing this button again to
stop the operation.
2 SWING BUTTON
Activate the automatic air swing function.
3 FAN SPEED BUTTON
Select the fan speed LOW, MID, HIGH and AUTO in sequence.
4 TIME/TEMP BUTTON
Press the
Press the
The temperature setting range is from 16~30°C.
For the time setting range from 0~10 hours, press the
selected time on 0.5 hour increment, and press the
selected time in 0.5 hour decrement.
For the time setting range from 10~24 hours, press the
selected time on 1 hour increment, and press the
time in 1 hour decrement.
5 SIGNAL RECEIVER
6 MODE BUTTON
Select the operation mode COOL, DRY, FAN (for cooling only model).
7 FILTER BUTTON
This feature is a reminder to clean the Air Filter (See Care and Cleaning) for
more efficient operation and cooling. The LED (Light) will illuminate after 250
hours of operation. To reset after cleaning the filter, press the "Filter" button
and the light will go off. Before the LED (Light) illuminate, press th
for 3 seconds to clear the accumulated time of operation.
keypad to increase the set (operating) temperature of the unit.
keypad to decrease the set (operating) temperature of the unit.
- 7
5
1
6
keypad to decrease the
keypad to decrease the selected
-
RAW-XH07CA
RAW-XH10CA
RAW-XH13CA
RAW-XH18CA
RAW-XH24CA
keypad to increase the
keypad to increase the
ilter" button