Table of Contents
Advertisement
Wiring diagram for a dual-view system:
¼ Note:
For alternative ways to connect the yellow wire, refer to page 18.
Connect transducer
Connect the transducer cable to the SONAR port of the sonar module. Securely support
the cable with cable ties.
WARNING:
Leave enough slack in the cable so you can adjust the transducer to all
⚠
possible views (forward/down/scout). Also leave enough slack in the cable loop to
ensure the motor shaft can spin all the way around without damaging the cable.
Connect Ethernet cable
Connect the Ethernet cable to the ETHERNET port of the sonar module. Connect the
other end to your multi-function display (MFD) or Ethernet expansion device.
Connect power cable
The sonar module can be powered by a 12 or 24 V DC system. It is protected against
reverse polarity, under voltage, and over voltage (for a limited duration).
The yellow wire in the power cable is used to control how the unit is turned on and off.
The blue wire isn't used in a single view system (one sonar module and transducer), but it
is used in a dual view system (two sonar modules and transducers).
WARNING:
You should always connect the positive supply wire (red) to (+) DC
⚠
with a fuse or circuit breaker. For recommended fuse rating, refer to the Technical
specifications section of this manual.
Grounding
_
+
Ethernet
Ethernet
17
Hide quick links:
Advertisement
Table of Contents
