Komatsu WA380-6 Operation & Maintenance Manual page 231

TROUBLESHOOTING
CONNECTING THE BOOSTER CABLE
Keep the starting switch of the normal machine and problem machine in the OFF position.
Connect the booster cable as follows, in the order of the numbers marked in the diagram.
1. Connect the clip of booster cable (A) to the positive (+) terminal
of battery (C) on the problem machine.
2. Connect the clip at the other end of booster cable (A) to the
positive (+) terminal of battery (D) on the normal machine.
3. Connect the clip of booster cable (B) to the negative (-) terminal
of battery (D) on the normal machine.
4. Connect the clip at the other end of booster cable (B) to engine
block (E) on the problem machine.
STARTING ENGINE
Always check that the work equipment lock lever is set to the LOCK position, regardless of whether the machine is working
normally or has failed. Check also that all the control levers are in the HOLD or NEUTRAL position.
1. Make sure the clips are firmly connected to the battery terminals.
2. Start engine of the normal machine and run it at high idle speed.
3. Turn the starting switch of the problem machine to the START position and start the engine.
If the engine doesn't start at first, wait for at least 2 minutes before trying again.
DISCONNECTING THE BOOSTER CABLE
After the engine has started, disconnect booster cables in the reverse order in which they were connected.
1. Remove the clip of booster cable (B) from engine block (E) on
the problem machine.
2. Remove the clip of booster cable (B) from the negative (-)
terminal of battery (D) on the normal machine.
3. Remove the clip of booster cable (A) from the positive (+)
terminal of battery (D) on the normal machine.
4. Remove the clip of booster cable (A) from the positive (+)
terminal of battery (C) on the problem machine.
3 - 174
WARNING
OPERATION