Nice elero Aero-868 AC Operating Instructions

Aero-868/915 AC Operating instructions
28 460 0006
66
35
135
200
Advice: Horizontal mounting positi-
General information
Aero-868/-915 AC is a combined sun/wind/radio control device for
your awning and venetian blinds.
Important!
The Aero-868/-915 AC only operates in combination with radio
receivers from the elero ProLine-868 radio system.
Radio signals (frequency 868.3 MHz) are transmitted between the
Aero-868/-915 AC and the receiver. Power supply is via connec-
tion to the mains network.
Recommendation: Use a LumeroTel or VarioTelPlus manual
transmitter in connection with the Aero-
868/915 AC to deactivate the sun function.
Safety instructions
Risk of injury due to electrocution.
Warning!
• Connections must be performed by an authori-
sed specialist.
Important safety instructions!
Observe the following instructions.
• Only use unmodified original elero electrical parts.
Warning!
• Keep persons away from the operating range of
the system.
• Keep children away from the controls.
• Follow the relevant country-specific regulations.
• If one or more devices are used for controlling the
system, the operating range must stay visible duri-
ng operation.
• The device contains swallowable small parts.
• Radio stations transmitting in the same frequency
range may cause reception interference.
• Please note that the operating range of the radio
signal is limited by legislation as well as by the
product design.
80
on. Light sensor on top.
Wind monitor below.
Intended use
The Aero-868/-915 AC may only be used for control of awnings
and venetian blind installations.
Third-party devices should only be connected after consultation
with your specialised dealer.
• Please ensure that the radio installations are not operated in
areas of heightened possible interference. (e.g. hospitals, air-
ports ...).
• The remote control is only approved for devices and systems
for which any malfunction of the manual transmitter or receiver
would not result in a risk for persons, animals or property, or if
such a risk is covered by other safety devices.
• The operator has no protection whatsoever from interferences
by other radio emitters and local terminals (e.g. also from radio
installations), that are normally used on the same frequency
range.
• Only use radio receivers with equipment and units approved by
the manufacturer.
DOWN
button
(Sun symbol)
Off
4
yellow LED
(Light value)
Electrical connection of the Aero-868 AC
1. Switch off the mains voltage.
2. Connect the cables to the Aero-868 AC according to colour:
blue = N
black = L
3. Switch on the mains voltage.
The green operating LED indicates readiness for operation.
Connection
b
Connect at least a 2-core cable
(UV resistant 0,75–1,5
of your Aero-868 AC.
The connection of the protective earth is not
necessary.
Power consumption: > 2 watt
1. Remove the wall fixing screws (b) of the Aero-868/-915 AC.
2. Remove the cover.
3. Connect the Aero-868/-915 AC.
4. Replace the cover on the device.
5. Screw on the cover again.
green LED
(transmit)
Function
position
UP button
5
(Wind symbol)
red LED
(Wind value)
L
N
2 ) to terminals L and N
181007306_EN_0423