Summary of Contents for FOUNTAINS.COM Bjorn FT-107A
Page 1
FT-107 Bjorn Fountain Assembly Instructions Fountain Information: • This fountain holds approximately 1 gallon of water. • This fountain uses a small fountain cover: FTNCOV-SM • No rell device or submersible lights are suggested or this ountain. Pump Information: WP450LV - 120 GPH Low Voltage Pump (16 ft. cord length) Tools Required: Bubble Level Screwdriver...
Page 2
FT-107 Bjorn Fountain Assembly Instructions Professional installation is recommended for this fountain! Fountain Set-Up: Assembly & Installation - A ountain can be dicult to install without knowing and understanding the steps involved. To ensure your ountain is installed properly, please read our instructions and tips beore you begin. Step 1 - Seek Professional Help: Check i...
Page 3
FT-107 Bjorn Fountain Assembly Instructions Professional installation is recommended for this fountain! Step 7 - Insert the CPVC end o the tubing assembly into the bottom o the water eature (FT-107A). Step 8 - Center the water eature (FT-107A) in the basin (FT-107B) ensuring that it is level. 8a - Turn the eature and coil the tubing as you lower it into position.
Page 4
Maintenance: Pump Care - The ountain relies heavily on the quality o the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is ully submerged at all times to avoid damage. Step 2 - Ensure water level is sufcient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.