Blaupunkt GT7010 Instruction Manual page 11

GT7010
Dispensing the string:
The device is equipped with an automatic string dispensing system
which ejects a certain amount of string every time the trimmer is started.
The excess of the dispensed string is cut by the cutter.
Cleaning and maintenance
1. After each use clean the entire device of plant residues and the lower cover of the collected
compacted mass.
2. Ventilation slots and motor housing should be kept free of dust and dirt, as much as possible. Wipe
the device with a clean cloth, brush or purge with compressed air.
3. It is recommended to clean immediately after every use.
4. Do not use any cleaning agents or solvents to clean the device; they may damage the plastic parts.
Take care not to allow water to enter the device.
5. Check the condition of the cutting string regularly, as well as the tightening of the screws. With new
devices, the bolt tightening should be checked after about 2 first hours of operation. Tighten the
loosened bolts if necessary.
6. Ensure that all components of the power tool are in good working order and do not overload or carry
out any work for which the device is not intended
Grass trimmer
Power: 550 W
Rotational speed: 10000/min
Cutting diameter: 290 mm
String diameter: 1.4 mm
Double string
Adjustable length (telescopic rod)
Flower stopper
Head angle adjustment
Cord length: 200 mm
Head Type: automatic
Noise and vibrations.
The noise and vibrations have been measured in accordance with En786
Noise emission: Sound pressure level (LpA): 80.20 dB (A)
KpA deviation: 3.00 dB (A)
Measured sound power level LwA: 94.50 dB (A)
KwA deviation: 1.91 dB (A)
Guaranteed sound power level: LwA: 96.00 dB (A)
Total vibration value and measurement uncertainty (K):
The value of vibrations acting on the upper limbs: 3.07 m/s² , k= 1.50 m/s²
The declared total vibration value has been measured according to the standard test method and can
be used to compare one device to another. The given vibration emission value may be used for the
preliminary estimation of the negative impact.
After every 15 minutes of work allow 15 minutes break.
9