Low Speed Custom Solutions Header - Intel NUC5i5MYBE Product Specification

DMIC_CLK, DMIC_DATA: clock output and data I/O for digital microphone interface; allows
•
connection of a Digital Microphone.
• SCI/SMI GPIO: input signal for direct connection to a signal (such as a front panel push-
button) capable of triggering an OS-level command in Windows (formerly referred to by
Microsoft as Direct Application Launch*). Voltage level I/O for this pin is 3.3 V. Refer to below
URL for accompanying utility to map triggered event to Windows
https://downloadcenter.intel.com/Detail_Desc.aspx?lang=eng&DwnldID=22035
I2Cx_CLK, I2Cx_DATA: Inter-Integrated Circuit (I
•
of low-speed peripherals. Voltage level I/O for these pins is 3.3V. An I
user manual may be found at http://www.nxp.com/documents/user_manual/UM10204.pdf.
SMB_CLK, SMB_DATA, SMB_ALERT#: System Management Bus (SMBus) interface signals.
•
Voltage level I/O for these pins is 3.3 V. General SMBus information can be found on the
platform EDS and at http://smbus.org/specs/.
2.2.4.6 High Speed Custom Solutions Connector (0.4 mm Pitch)
The High Speed Customs Solution connector is designed to provide access to additional high
speed signals. It provides the equivalent of:
• One PCIe x4 port
• One 6.0 Gbps SATA port
The connector used is the Kyocera Series 6885 0.4 mm pitch FPC connector, p/n 00 6885 640
000 846.
Figure 17. Low Speed Custom Solutions Header
file.
C) bus interface signals that allow connection
2
2 C bus specification and
Technical Reference
61