Table of Contents
Advertisement
Displaying From a Mac Laptop
If you see the "No Signal" message when you display from a Mac laptop, you need to set up the laptop
for mirrored display. (See your laptop manual for details.)
1. Open the System Preferences utility and select Displays, Display, or Color LCD.
2. Click the Arrange or Arrangement tab.
3. Select the Mirror Displays checkbox.
Parent topic:
Solutions When "Not Supported" Message Appears
If the "Not Supported" message appears, try the following solutions:
• Make sure the correct input signal is selected on the Signal I/O menu.
• Make sure the computer's display resolution does not exceed the projector's resolution and frequency
limit. If necessary, select a different display resolution for your computer. (See your computer manual
for details.)
• If you are projecting from an HDMI source, change the HDMI IN EQ Level setting in the projector's
Signal I/O menu. Follow the on-screen instructions. You may need to restart the projector.
• If you are projecting using a thumb-sized media streaming device, set the HDMI EQ Setting to 1 in the
projector's Signal I/O menu.
Parent topic:
Solutions When Only a Partial Image Appears
If only a partial computer image appears, try the following solutions:
• For VGA connections, press the Auto button on the remote control to optimize the image signal.
• Make sure you selected the correct Screen Type setting in the projector's Installation menu for the
screen you are using. If there are margins between the edge of the image and the projected screen
frame, use the Screen Position setting to adjust the position of the image.
• Make sure the Scale setting in the Image menu is turned off (EB-L210SF).
• Make sure the Resolution setting in the Image menu is set correctly for the input signal.
• Try adjusting the image position using the Position setting in the Image menu.
• Press the Aspect button on the remote control to select a different image aspect ratio.
• If you zoomed into or out of the image using the E-Zoom buttons, press the Esc button until the
projector returns to a full display.
Solutions When "No Signal" Message Appears
Solving Image or Sound Problems
249
Advertisement
Table of Contents
