TonerRefillKits ReChargX RX076 Instructions Manual

ReChargX™ RX076 Instructions
For use in the Canon EP-J toner cartridges
The Canon EP-J is the toner cartridge most
frequently found in the Canon LBP-720, 730,
740, 750, 830, Xante Accel-A-Writer 8300 and
all other machines using the same underlying
"engine" (figure 1).
This toner cartridge is quite easy to refill using
our ReChargX™ RX076 Premium Print Toner
Refill Kit.
Within these ReChargX™ RX076 Premium
Print Toner Refill Kit instructions, we will be
adding new toner and removing the waste
toner.
Step 1: Plug in the Hole-Making Tool
Plug in the hole-making tool included with the
ReChargX™ Tool Kit.
Turn the sand timer over and wait the full three
minutes before using the tool so it reaches
proper operating temperature; this ensures the
tool will easily penetrate the cartridge housing
(figure 2).
Step 2: Find the Toner Hopper Hole
Location
With the toner cartridge in the same orientation as
it would be if you were installing it into the printer,
the toner hopper hole will be placed in the lower
left corner of the cartridge, as shown by the white
circle in figures 3a and 3b.
TonerRefillKits.com
Mon - Fri 8am - 5pm ET
800.527.3712 or 352.343.7533
© 1995-2012 ReChargX™, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the
ReChargX™ and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
Figure 1: The Canon EP-J toner cartridge
Figure 2: Wait for the hole-making tool to heat up
Figure 3a: Find the toner hopper hole location
Figure 3b: Find the toner hopper hole location
RechargX™ RX076 v2
2012.02.09
Page 1 of 7