Table of Contents
Advertisement
66
GENERAL INFORMATION
Preparing your Remote Control
The Remote Control handset is needed to operate your new Toshiba video recorder. If used correctly, it should give years of
trouble-free use. Please take good care of it, always observing the correct polarities when replacing the batteries.
Batteries:
Carefully open the battery compartment on the
rear of the Remote Control by gently pushing on
the arrow and sliding in that direction.
Insert both batteries taking care to fit them the
right way round (+ and –).
The 2 Toshiba batteries supplied are Cadmium-
and Mercury-free (UM-4, AAA, IECR03, 1.5v).
Replace the cover of the battery compartement.
By sliding in the opposite direction to the arrow.
CAUTION:
DO NOT throw your batteries into a fire.
Dispose of your batteries in a designated
disposal area.
DO NOT mix an old battery with a new one.
DO NOT mix battery types.
Caring for the Remote controller
•
When using the Remote Control, press the buttons at intervals of about 1 second to ensure the correct mode of operation.
•
Keep the Remote Control away from extremely hot or humid places and avoid sharp impacts.
•
Do not expose the remote sensor of the VTR to a strong light source such as direct sunlight or illumination (especially high-
frequency lighting) when using the remote control.
•
Be careful not to spill water on the Remote Control or to place it on anything wet.
Effective Range for the Remote Control:
For optimum performance your Remote Control
will operate within a distance of 7 metres and
up to 30° from the central position.
If the Remote Control does not work, press the
VTR button and make sure the batteries are in
good working order.
6
ON/STANDBY
EJECT
I N N OVAT I V E
T ECHNOLOGY
CHANNEL
REC
REW
PLAY
FF
STOP
7 m
30
o
30
o
66
CONNECTIONS
Connecting your VTR
You must take into account various factors when connecting audio or video system :
•
Types of connectors available on your systems
•
Systems connected permanently to the VTR or temporarily (camcoder for example)
Deciding how to connect your VTR
Your VTR is equipped with the following connector.
Connectors
Location
Type
AV1
Rear
SCART
AV1(EURO AV)
OUT TO TV
Rear
75Ω
coaxial
TV
IN FROM ANT.
Rear
75Ω
coaxial
Important:
Whenever you connect an audio or video system to your VTR, ensure that all element are switched off.
Refer to the documentation supplied with your equipment for detail connection instructions and associated safety
precautions.
Direction
Recommended Use
•
In/Out
Television
•
Other VTR
•
Out
Television
•
In
Aerial
•
Cable television network
7
Advertisement
Table of Contents
