Table of Contents
Advertisement
02.99
08.06
04.01
900 / P954.0
Operation not enabled
Cause
Bits to enable the drive missing.
Remedy
Set enable signals in the control word (STW).
Acknowledgement
not required
Stop response
None
901 / P954.1
Illegal operating status
Cause
If the program is running, jogging or referencing is not possible.
Remedy
–
Acknowledgement
not required
Stop response
None
902 / P954.2
Single block active
Cause
If the program is running and in the single block mode, jogging or refe-
rencing is not possible.
Remedy
–
Acknowledgement
not required
Stop response
None
903 / P954.3
Both jogging signals active
Cause
–
Remedy
–
Acknowledgement
not required
Stop response
None
904 / P954.4
Positioning mode not enabled
Cause
Operating condition for program missing (STW.4).
Remedy
–
Acknowledgement
not required
Stop response
None
905 / P954.5
Axis has still not been moved
Cause
The axis was still not moved after power-on.
Remedy
–
Acknowledgement
not required
Stop response
None
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
6 Fault Handling and Diagnostics
6.2 Faults and warnings
6
6-247
Advertisement
Table of Contents
