Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Ergolux ELESTNDSKNA
Summary of Contents for Ergolux ELESTNDSKNA
- Page 1 ELECTRIC STANDING DESK ELESTNDSKNA, ELESTNDSKBA & ELESTNDSKWA...
-
Page 3: Safety And Warnings
SAFETY & WARNINGS • Read all instructions before use and retain this user guide for future reference. • Read all following safety precautions carefully before use. • Your equipment is intended for use in cool, dry conditions. You should avoid storage in extreme cold, hot or damp areas as this may lead to corrosion and other related problems. - Page 4 COMPONENTS Lay all components out on a clean floor and ensure all parts are included. If any pieces are missing, check all packaging thoroughly, then contact help.Kogan.com for assistance. A Desktop B Sync Rod C Lifting Column D Lifting Column E Side Bracket (x2) F Foot (x2) G Crossbar (x2)
- Page 5 Hardware List S-A M4x40 S-B M6x12 Hex S-C M6x30 Hex S-D ST4.0x12 Head Screw (x22) Head Screw Phillips Head Screw (x4) Phillips Head Screw (x10) (x4) Tools Required 4mm Allen key (included) Spirit Level Phillips Head Screwdriver...
- Page 6 ASSEMBLY Step 1: Installing the feet. • Attach the Feet (F) to the bottom of the Lifting Columns (C)(D) using x8 M6x30 Hex Head Screws (C). S-C (x8) 4mm Allen key...
- Page 7 Step 2: Attaching the Sync Rod • Insert the end of the Sync Rod (B) without the notch though the Motor (H). • Insert the Sync Rod (B) into the holes on the Lifting Columns (C)(D). • Secure the motor in place using x2 M4x40 Phillips Head Screws (S-A). S-A (x2) Notch...
- Page 8 Step 3: Attaching the Crossbars • Attach the Crossbars (G) to the Lifting Columns (C)(D) using x8 M6x12 Hex Head Screws (S-B). Note: Ensure the screws are inserted into the outer most holes on the crossbars and lifting columns. S-B (x8)
- Page 9 Step 4: Attaching the Side Brackets • Attach the Side Brackets (E) to the Lifting Columns (C)(D) using x4 M6x12 Hex Head Screws (S-B). Note: Ensure the Side Brackets are attached to the two holes second from the top of the upper edge of the lifting columns.
- Page 10 Step 5: Attaching the Desktop • Lay the Desktop (A) face down on a soft, flat surface (carpet, blanket etc.). • Attach desk frame assembly to the Desktop (A) using x8 M6x12 Hex Head Screws (S-B). S-B (x8) Blanket Step 6: Connecting the Controller •...
- Page 11 Step 7: Attaching the Controller • Attach the Controller (J) to the Desktop (A) using x2 ST4.0x12 Screws (S-D). S-D (x2)
- Page 12 Step 8: Adjusting the Desk • Turn the Desk back over to the upright position. • Use a spirit level to ensure the desk is level and stable. Each foot has two adjustable pads that can be rotated to raise or lower the desk. CAUTION: To avoid serious injuries, at least two people are required when turning the desk over.
-
Page 13: Operation
OPERATION Display Raise Lower Memory Settings 1/2/3 Before First Use When the desk is first powered on, the height will be displayed on the controller. If this number does not match the actual height of the desk, the system will need to be reset before use. - Page 14 Memory Setting To save a position to one of the three memory buttons, first adjust the desk to the desired height. Press the “S” button, the display will flash the current height then press either the “1”, “2” or “3” button. The current height will be stored to the respective button. To use one of the saved positions, press either the “1”, “2”...
- Page 15 Setting a Custom Minimum & Maximum Height Limit Press and hold the “S” button until “HLP” is displayed. The display will alternately flash “HLP” and the current height. Adjust the desk to your desired maximum height and press “1”. The display will flash “H-P”, press “S”...
-
Page 16: Troubleshooting
TROUBLESHOOTING The following tips will help you detected and eliminate some common faults and errors. If the problem cannot be fixed or the fault is not listed below, please contact help.Kogan.com for support. Error Code Solution The control panel is disconnected. Check the connection. - Page 17 NOTES...
- Page 20 Need more information? We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com...
Need help?
Do you have a question about the ELESTNDSKNA and is the answer not in the manual?
Questions and answers