Flight Mode Setup; Spoken Flight Mode - Spektrum NX20 Instruction Manual

EN

Flight Mode Setup

Use the Flight Mode Setup menu to assign switches to flight modes.
Select Switch 1, scroll to choose a switch. Enabled Flight Modes
will show how many flight modes are available with the chosen
switch(es). Flip the switch to see what the flight mode will be in
each switch position, the mode is displayed at the bottom of the
page. If you require more than 3 flight modes, select another
switch for Switch 2.
You can assign up to ten flight modes using any combination of
up to three switches. The maximum number of flight modes and
switches available depend on model type.
See the options based on aircraft type in the table below. In
Sailplane mode you can also assign a priority switch. When the
priority switch position is active, only the current flight mode is
active, regardless of other switch positions.
Mode Number of Switches
ACRO 3
HELI 3 (including Throttle Hold)
SAIL 3
MULTI 2

Spoken Flight Mode

Spoken Flight Mode enables you to chose what you want the
transmitter voice callout to be for flight mode changes.
1. Set up the flight modes on the Flight Mode Setup page.
2. View the Spoken Flight Mode page from the System Setup
menu.
3. Set the flight mode switch position(s) so the flight mode
where you want to make changes is selected. Select the flight
mode you wish to change by setting the flight mode switch
position(s) to that flight mode. The selected flight mode is
shown in the F-Mode Name (by default, unless you change the
flight mode names).
4. Select F-Mode Name to change the written name of the flight
mode. Choose the name of the flight mode by pressing the
scroll wheel to select and rolling to change the selection.
Press the back key to exit.
5. Select Speak to choose the desired voice callout.
IMPORTANT: If you select a telemetry data point it must have
that sensor information available from the model or it will just
say "no data"
6. Test the voice callout by scrolling to TEST and pressing the
scroll wheel.
16
Number of Flight Modes
10
5 (including Throttle Hold)
10
5
Flight Mode Table
Select NEXT from the Flight Mode Setup menu to access the Flight
Mode Table menu. This is where you define how the combination
of switches is used to access all of the available flight modes.
The assigned switch(es) and their current position are shown
at the top. In the center of the screen the table gives a visual
representation of the switch position. Press the scroll wheel when
FLIG is selected and the box will change to show flight mode
selection. Then, you can roll the scroll wheel to change the flight
mode for that position on the table. Flip through all possible
combinations on your selected switches and define what flight
modes you want for each combination.
Flight Mode Wizard
Press PREV from the Flight Mode Setup menu to access the Flight
Mode Wizard.
SPEKTRUM NX20 • TRANSMITTER INSTRUCTION MANUAL