Figure 5: Bushing Assembly Parts - Motorola HAF4015 Installation Manual

Figure 5: Bushing Assembly Parts

Table 2: Bushing Assembly Parts Description
Number
9 Insert the bushing assembly in the enclosure hole, and then slip the alignment ring over the
bushing assembly and into the enclosure hole.
10 Screw the locking nut onto the bushing assembly
11 Use the adjustment nut to set the correct height of the bushing assembly. The locking nut is
properly positioned when the top of the nut is level with the bottom edge of the coaxial cable
connector insulator.
12 Using a 15/16-in. open-end wrench, tighten the threaded flange until the bushing assembly is
firmly attached to the enclosure
13 Apply silicone grease to the weatherproof rubber seal.
14 Slide the rubber seal down and around the locking nut so that it sits immediately on top of the
enclosure.
15 Position the antenna over the locking nut, and secure the metal cap to the external threads of
the locking nut.
1
2
3
1
2
3
4
5
6
Chapter 2 : Installation
4
5
6
MAEPF-27627-O
Description
Rubber Seal
Locking Nut
O-Ring
Alignment Ring
BushingAssembly
Adjustment Nut
MN007792A01-AA
13