Hu Eredeti Használati Utasítás - Hilti TE 7-C Manual

Trouble or fault
No hammering action.
The rotary hammer doesn't
achieve full power.
The drill bit does not rotate.
The drill bit cannot be re-
leased.
The drill bit makes no
progress.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r3509.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Eredeti használati utasítás
1 A használati utasításra vonatkozó adatok
1.1 A használati utasításhoz
• Üzembe helyezés előtt feltétlenül olvassa el a használati utasítást. Ez a biztonságos munkavégzés és a
hibamentes kezelés előfeltétele.
• Vegye figyelembe a használati utasításban és a terméken található biztonsági utasításokat és figyelmez-
tetéseket.
• Ezt a használati utasítást mindig tárolja a termék közelében, és a terméket csak ezzel a használati
utasítással együtt adja tovább harmadik személynek.
*202933*
Possible cause
The power tool is too cold.
The function selector switch is set
to "Drilling without hammering"
The gauge (cross section) of the
extension cord conductors is inad-
equate.
The control switch is not fully
pressed.
The function selector switch is not
engaged or is in the
or "Chisel adjustment" position.
The chuck is not pulled back fully.
The power tool has been set to
reverse rotation.
202933
Action to be taken
▶ Bring the tip of the drill bit
into contact with the working
surface, switch the rotary
hammer on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
▶ Set the function selector
. switch to the "Drilling with
hammering action" (hammer
drilling) position
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Press the control switch as far
as it will go.
▶ Set the function selector switch
"Chiseling" to "Drilling without hammering"
or "Hammer drilling"
▶ Pull the tool lock back as far
as it will go and remove the
accessory tool.
▶ Set the power tool to forward
rotation.
.
.
Magyar 17