Page 1
TE 7 Operating instructions Mode d’emploi Manual de instrucciones Manual de instruções Printed: 08.07.2013 | Doc-Nr: PUB / 5071114 / 000 / 01...
Page 2
This Product is Certified Ce produit est homologué Producto homologado por Este produto está registrado Printed: 08.07.2013 | Doc-Nr: PUB / 5071114 / 000 / 01...
In these operating instructions, the designation “the Always keep these operating instructions to- power tool” always refers to the TE 7 rotary hammer. gether with the power tool. Operating controls and parts 1 Ensure that the operating instructions are...
Changes or modifications to the power tool are not permissible. To avoid the risk of injury, use only genuine Hilti accessories and insert tools. Observe the information printed in the operating instructions concerning operation, care and maintenance.
Power tool TE‑C CLICK chuck Side handle with depth gauge Operating instructions Hilti toolbox Cleaning cloth Grease 2.8 Using extension cords Use only extension cords of a type approved for the application and with conductors of adequate cross section. The power tool may otherwise loose performance and the extension cord may overheat.
120 V Rated current input 6.3 A Rated frequency 60 Hz Power tool TE 7 Weight 2.9 kg (6.39 lb) Dimensions (L x W x H) 320 mm (12.6") x 75 mm (2.95") x 215 mm (8.46") Speed under no load 0…1,050/min...
Page 9
5.1.2 Electrical safety 5.1.4 Power tool use and care a) Power tool plugs must match the outlet. Never a) Do not force the power tool. Use the correct modify the plug in any way. Do not use any adapter power tool for your application. The correct power plugs with earthed (grounded) power tools.
Page 10
Hilti reproductive harm; or serious and permanent res- Service Center. Under unfavorable circumstances, piratory or other injury.
hat, ear protection, protective gloves and breathing 5.3.5 Personal protective equipment protection while the machine is in use. The user and any other persons in the vicinity must wear ANSI Z87.1-approved eye protection, a hard 6 Before use Release the side handle clamping band by turning the handle counterclockwise.
Page 12
Check that the insert tool has engaged correctly by CAUTION pulling it. The work generates noise. Wear ear protectors. Expo- sure to noise can cause hearing loss. 7.1.3 Removing the insert tool 5 7.2.1 Working at low temperatures NOTE The hammering mechanism works only when the power tool has reached a minimum operating temperature.
Clean the sealing lip by wiping it 8.1 Care of insert tools carefully and then grease it again lightly with Hilti grease. Clean off dirt and dust deposits adhering to the insert It is essential that the dust shield is replaced if the sealing tools and protect them from corrosion by wiping the lip is found to be damaged.
10 Disposal Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools or appliances for recycling.