Seagate ST8000VP001 Product Manual page 10

www.seagate.com
Table 1 Drive specifications summary (continued)
Drive Specification*
Operating temperature
(drive case max °C)
Temperature gradient
Relative humidity
Relative humidity gradient (max)
Wet bulb temperature (max)
Altitude, operating
Altitude, non-operating
(below mean sea level, max)
Operational shock (max)
Non-operational shock (max)
Vibration, operating
Vibration, non-operating
Drive acoustics, sound power
Idle***
Seek
Non-recoverable read errors
Rated workload
Warranty
Load/unload cycles
(at 25°C, 50% rel. humidity)
Supports hotplug operation per the
Serial ATA Revision 3.2 specification
* All specifications above are based on native configurations.
** One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity.
Accessible capacity may vary depending on operating environment and formatting.
*** During periods of drive idle, some offline activity may occur according to the S.M.A.R.T.
specification, which may increase acoustic and power to operational levels.
† Seagate does not recommend operating at sustained case temperatures above 60°C.
Operating at higher temperatures will reduce useful life of the product.
# The operating case temperature is 0 to 70C (32 to 158F).
The recommended measure location can be found in
If the drive is powered-off before issuing flush cache command, in some instances,
Note
the end user data in the DRAM cache might not be committed to the disk.
Seagate SkyHawk Product Manual, Rev. F
ST8000VX002, ST6000VX001,
ST8000VP001, ST6000VP001,
ST8000VX008 ST6000VP000
30°C per hour max (non-operating)
80 Gs (read) / 70 Gs (write) at 2ms
10Hz to 22Hz: 0.25 Gs, Limited displacement
Average annualized workload rating: <180TB/year.
The specifications for the product assumes the I/O workload does not exceed the average
annualized workload rate limit of 180TB/year. Workloads exceeding the annualized rate may
degrade and impact reliability as experienced by the particular application. The average
annualized workload rate limit is in units of TB per calendar year.
To determine the warranty for a specific drive, use a web browser to access the following web
page: http://www.seagate.com/support/warranty-and-replacements/
From this page, click on "Is my Drive under Warranty". Users will be asked to provide the drive
serial number, model number (or part number) and country of purchase. The system will
display the warranty information for the drive.
Section 3.4 Figure
ST4000VX005,
ST4000VP001, ST3000VX009
ST4000VX013
†
70°
20°C per hour max (operating)
5% to 90% (operating)
5% to 95% (non-operating)
30% per hour
30°C max (operating)
40°C max (non-operating)
–304m to 3048m
(–1000 ft to 10,000 ft)
–304m to12,192m
(–1000 ft to 40,000+ ft)
300 Gs at 2ms
22Hz to 350Hz: 0.50 Gs
350Hz to 500Hz: 0.25 Gs
5Hz to 22Hz: 3.0 Gs
22Hz to 350Hz: 3.0 Gs
350Hz to 500Hz: 3.0 Gs
2.6 bels (typical)
2.7 bels (max)
2.7 bels (typical)
2.8 bels (max)
14
1 per 10 bits read
600,000
Yes
2 & 3.
Drive Specifications
ST2000VX012,
ST2000VP001,
ST2000VX015
350 Gs at 2ms
9