Table of Contents
Advertisement
Chapter 02
Preparations
Installation
Attaching the Stand
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
― Disassembly is the reverse order of assembly.
4
3
Push the assembled stand into the main body in the direction of the arrow as
shown in the figure. Tightly fasten the connecting screw at the bottom of the
main body.
1
1
x 2
Put the stand base onto the stand
neck as the direction shown in the
figure. Check that the stand neck is
firmly connected.
5
4
Stand assembly is complete.
2
3
4
Tightly fasten the connecting screw at
As shown in the figure, remove the
the bottom of the stand base. Fasten
product and foam cushion, and then
the large screw in the middle for
place the product on the table with its
assembly.
front side facing the floor.
Caution
Do not arbitrarily remove the panel
film. If not observed, the warranty
service may be restricted.
9
Advertisement
Table of Contents
