Table of Contents
Advertisement
NOTICE
NEVER use an pneumatic air gun to tighten wheel
lug nuts.
3. After first road use, retorque all lug nuts in sequence.
Check all wheel lug nuts periodically.
1
4
3
2
4-LUG NUTS
1
3
6
4
5
2
6-LUG NUTS
LUG NUT
Figure 38. Wheel Lug Nuts Tightening
Sequence
WM63SLF-MIXER • OPERATION MANUAL — REV. #0 (09/27/22) — PAGE 29
1
3
4
2
5
5-LUG NUTS
1
3
6
8
7
4
5
2
8-LUG NUTS
TORQUE
WRENCH
PNEUMATIC
AIRGUN
MAINTENANCE (MIXER)
SUSPENSION
The rigid type axle and associated hardware (Figure 39)
should be periodically inspected for signs of excessive
wear, elongation of bolt holes, and loosening of fasteners.
Replace all damaged parts immediately.
Figure 39. Axle Support Components
MIXER CLEANING
1. ALWAYS disconnect the spark plug wire before
cleaning the inside of the drum. In addition make sure
the clutch engagement lever is dis-engaged.
2. Make sure the rear section of the safety grate is
connected to the mixing drum.
3. At the end of each day's operation, place mixer drum in
an upright position and spray inside of tub immediately
with water to prevent lumps of dried mortar or plaster
from forming and contamination of future batches, DO
NOT allow a buildup of materials to form on the blades
or anywhere inside the drum.
4. Rotate mixer to dump position and remove debris.
5. Thoroughly clean the entire mixer, wheels, cabinet
and frame.
6. NEVER pour or spray water over the engine (Figure 40).
CHECK FOR
TIGHTNESS
RIGID TYPE
AXLE
Advertisement
Table of Contents
