Advertisement
Operating instructions
read the entire iMpOrtant SaFety inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
Make sure that the trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Drill Bit installation
cautiOn! Wear heavy‑duty work gloves
to provide protection when inserting and
removing drill bits. Drill bits become very hot during
use. Do not remove drill bit until the bit has cooled.
1. Rotate Chuck's Collar counterclockwise
to open or clockwise to close Jaws, so
that Jaws are slightly larger than bit.
2. Use a drill bit (sold separately) designed for the
workpiece type. Insert bit into center of Jaws.
note: For hex shank or three‑sided shank
bits, align flat sides of bit with Jaws.
Setting Speed
nOtice: Make sure Speed Switch is fully engaged in
either L or H position. Do not set in between speeds.
Do not set Speed Switch when Drill is running.
Set the desired speed by rotating the Speed Switch
(L = Low and H = High). Point arrow at desired speed.
Setting Direction
Set direction to Forward or Reverse by
pressing Direction Switch to left or right.
Page 8
For technical questions, please call 1-888-866-5797.
3. Lift bit slightly from bottom of chuck. Hand
tighten Collar clockwise until bit is held securely
in place and centered between Jaws.
4. Insert Chuck Key into one hole on side of Chuck
so that teeth on Key engages gear on Chuck.
Tighten securely. Repeat on other holes.
5. Remove bit by inserting Chuck Key into one hole on
side of Chuck so that teeth on Key engages gear on
Chuck. Turn Key counterclockwise and remove bit.
nOtice: use sharp bits. Dull, bent, or
damaged bits may cause binding and
put stress on the drill and/or bit.
Forward
Direction
Switch
arrow
Speed
Switch
reverse
Item 64121
Advertisement
