Table of Contents
Advertisement
GmbH, Stettiner Str. 38, D-33106 Paderborn
2 Installation and startup
2.1 Mounting the case
On the rear side of the housing there is a special mechanism for fixing the device on a
rail TS35 according to DIN EN 50022. Please pull the mechanism to the open position
using a small screw driver. When you press the device onto the rail the mechanism
automatically snaps in. Please ensure that the case is mounted with the the serial no.
label on the top side.
2.2 Opening the front cover
To deactivate the write protection the front cover of the housing cover can be removed
by use of a small screw driver. The unprotect pushbutton is then accessible from
outside; the unit is unprotected by pressing this button.
Attention: Afterwards please fix the cover oriented with the notch at the top. You can
use a suitable adhesive seal to prevent the housing from being opened unnoticed.
2.3 Connecting
The following picture shows a typical installation including the PadPuls M1C:
level converter
PC
- Bus
power supply
24V
-
+
PadPuls M1C
PadPuls M1C User Manual
26.09.01, Version 1.3
3
Advertisement
Table of Contents
