PaloAlto Networks WF-500-B Hardware Reference Manual page 32

Service the WF-500-B Appliance
STEP 3 | Press the ejector button on the carrier of the failed drive (A2 in this example) to release
the carrier handle and gently pull the handle toward you and slide the carrier out of the
appliance.
STEP 4 | Remove the replacement drive from the packaging and compare the drive model written on
the label with the drive model of the failed drive. Proceed as follows based on your findings:
• If the replacement drive is the same model number of the failed drive that you removed,
then continue to Step 5.
• If the replacement drive is a different model number than the drive that you removed, then
continue to Step 6.
STEP 5 | (Same model replacement drive
as the other drive in the RAID 1 array.
1. Ensure that the drive carrier lever on the replacement drive is in the open position; if it is
not, press the ejector button on the drive carrier to release the lever and pull it out until
it is fully open.
2. Slide the drive carrier in to the drive bay on the appliance until it is about 1/4" from
being fully inserted. You can do this by pressing the ejector button on the carrier, which
WF-500-B Appliance Hardware Reference
only) Install a replacement disk drive that is the same model
32 2023 Palo Alto Networks, Inc.
©