Linde Warning Projector 85 pro Manual page 8

1. Intended Use
The device control connection is intended for
the following two applications:
1. Controlling the brightness of the projector,
including switching it on and off, via a po-
tential-free contact or 1-10V control. This al-
lows the projector to be controlled with an
external system.
2. Technical Overview
Control via potential-free contact:
closed = 0% | open = 100% brightness
Control via 1-10V DC:
3. Scope of Delivery
• Round connector, type Phoenix Contact
SACC-M12FS-5PL: for connecting a 1-10V
control cable to the Linde Warning Projector
85 pro.
• Cable jumper 40 mm with protective cap:
for activating the built-in automatic dimmer.
8
2. Activation of the built-in automatic dimmer,
which allows the projection to fade in and
out continuously. Speed and intervals are
pre-set and cannot be changed.
ATTENTION! The projector may be damaged
if the control connector is used improperly..
Only connect the projector to suitable control-
lers and follow the instructions in the informa-
tion for use.
4
3
① Control via potential-free contact / 1-10V
② Activation of the automatic dimmer
③ Control port
④ Cold-device built-in plug
Linde Warning Projector 85 pro
1
2