Linde Warning Projector 85 pro Manual page 10

5. Activation of the Automatic Dimmer
5.1 Inserting the Cable Jumper
1. Remove the terminal block from the sup-
plied round connector, type Phoenix Con-
tact SACC-M12FS-5PL.
2. Insert the supplied cable jumper as shown
in the illustration.
NOTE: Using the Push-Lock connection
Flexible conductors without ferrules or con-
ductors with large cross-sections can be easily
connected using the levers. The terminal point
is completely opened by the coloured lever and
remains in this open position. The conductor
connection is made by closing the lever. Wire
rigid conductors and conductors with ferrules
easily: through direct insertion. The contact
point does not have to be opened first. To dis-
connect a connected conductor, the lever is
moved to the open position and the terminal
point is opened. The conductors can then be
removed with ease.
5.2 Completing the Installation
1. Close the terminal block with the protective
cap supplied.
2. Insert the terminal block into the projector's
control port and secure it with the knurled
nut.
3. When the projector is switched on, the pro-
jection fades in and out continuously.
NOTE: The speed and intervals of the auto-
matic dimmer are pre-set and cannot be
changed.
10
grey
5
4 3
1 2
brown
Linde Warning Projector 85 pro