Table of Contents
Advertisement
5.4 Keyboard Installation
Note: Before removing the retaining screws ensure that the nerve monitor is switched
off and disconnected from the AC mains supply.
• Remove the retaining screw from the rear
panel of the touch screen DCU (right).
• Remove rear panel by sliding downwards
(indicated by an arrow).
• Insert the keyboard USB connector into any
internal USB socket.
• Route the cable through the gap provided
at the bottom of the monitor case (right).
• Replace rear panel and secure with the
retaining screw.
• Set the power switch to ON (I) (20, page
13).
To set the Keyboard language;
• From the home screen, press
• Press
• Press
• Select the relevant flag for the required language.
The Magstim Company Ltd.©
,
,
,
NOP20-EN-03
Retaining
Screw
Internal
USB Sockets
Gap for
Cable Routing
41
Advertisement
Table of Contents
