Cleaning Modes - Shark UV900 Series Owner's Manual

WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Power Off
I Hard Floor
For hard floors and small area rugs.
II Carpet
For carpets.
NOTE: For deep carpet cleaning per ASTM F608,
use setting II (Carpet) with MAX suction.
HEADLIGHT INDICATOR LIGHTS
HEADLIGHTS
The headlights will flash or turn red to
indicate issues that need attention.
Solid White Lights: The brushrolls are spinning and the unit is working as it should.
Solid Red Lights: There is a jam in the brushroll area. Turn off the vacuum and unplug it,
then remove any blockages in the nozzle.
Flashing Red Lights: The motorized floor nozzle is overheating. Turn off the vacuum, unplug
it, and remove any blockages. Let the vacuum cool down for at least 60 minutes before
restarting. See Troubleshooting section for more information.
Flashing White Lights: The vacuum is operating in an environment that is either too hot or
too cold. This vacuum will only function properly in temperatures ranging from 32°F (0°C)
to 104°F (40°C). Turn the vacuum off and adjust the room temperature.
NOTE: For deep cleaning per ASTMF608 (embedded dirt in carpets), please set to Carpet mode.
NOTE: For maximum suction for above-floor cleaning per ASTM F558, set to Hard Floor mode.
s h a r kc l e a n . c o m
SETTINGS
SUCTION CONTROL
The Suction Control Slider located on the
handle allows you to adjust the suction
depending on the floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on hard floors.
NOTE: The brushrolls spin in all modes
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT MODE
To engage Brushrolls, select a
surface setting, step on floor nozzle
and tilt handle back firmly.
ABOVE-FLOOR—HANDLE
Press the Handle Release button
and pull up on the handle to
detach it from the wand.
ACCESSORIES—HANDLE
Attach an optional cleaning
accessory to handle or wand.
NOTE: All accessories are compatible with both the wand and the handle. Included accessories will vary by model.
LIFT-AWAY MODE
Step on the pedal on the floor
nozzle to lift off the pod.
Wand
Release
ABOVE-FLOOR—WAND
Press the Wand Release button
and pull up on the wand to
detach it from the pod.
ACCESSORIES—WAND
s h a r kc l e a n . c o m