Conair Foot Rollers Instruction Booklet

IMPORTANT SAFETY
14) Never use while sleeping or drowsy.
INSTRUCTIONS 15) Keep the remote control module dry when possible. After use, store in a cool, dry place.
Avoid submerging or allowing to float on water for long periods of time.
When using an electrical appliance, basic precautions should always be followed, including the
following: Read all instructions before using this appliance.
DANGER–
To reduce the risk of electric shock: SAVE THESE INSTRUCTIONS
1) Always unplug this appliance from the electrical outlet immediately after
using and before cleaning.
2) Do not reach for an appliance that has fallen into water. Unplug immediately.
3) Do not place or store motor housing where it can fall or be pulled into the bathtub.
Do not fully immerse motor housing in or drop into water or other liquid. Store in dry place.
OPERATING INSTRUCTIONS
WARNING–
To reduce the risk of burns, fire, electric shock, or injury to persons:
This appliance has a polarized plug (one blade is wider than the other). As a safety feature,
1) An appliance should never be left unattended when plugged in. Unplug from outlet this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet,
when not in use, and before putting on or taking off parts. reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat
this safety feature.
2) This appliance should not be used by, on, or near children or individuals with certain
disabilities. This appliance is equipped with an Appliance Leakage Circuit Interrupter (ALCI), a safety
feature that renders it inoperable under some abnormal conditions, such as immersion in
3) Use this appliance only for its intended use as described in this manual. Do not use
water.
attachments not recommended by Conair.
To make sure the ALCI is functioning properly, perform the following test. The purpose of this
4) Never operate this appliance if it has a damaged cord or plug, if it is not working properly,
test is to allow you to make sure the exclusive water sensing system (ALCI) is working.
or if it has been dropped or damaged, or dropped into water. Return the appliance to
a service center for examination and repair. 1) Plug in appliance and press test button on plug (see diagram below).
5) Do not carry this appliance by supply cord or use cord as a handle. 2) Appliance will stop working. There will be an audible click and a reset button will pop out.
6) Keep the cord away from heated surfaces. 3) To reset ALCI with the reset button, unit should be unplugged.
Then push in reset button, and reinsert plug into outlet.
7) Never operate the appliance with the openings blocked. Keep the opening free
of lint, hair, and other particles. Do not operate on top of shag or loose pile rugs. 4) If ALCI is not functioning properly, return appliance to
an authorized Conair service center.
8) Never drop or insert any object into any opening.
5) It is important that if immersion of the transformer or the ALCI
9) Do not use outdoors.
occurs, this unit be brought to a service center. Do not try to reset.
10) Do not operate where aerosol (spray) products are being used or where
6) Be sure to repeat test every time you use appliance to confirm
oxygen is being administered.
ALCI is operational. Should the appliance go off and the ALCI reset
11) Before disconnecting, press the Off button of the remote.
button pop up during use, this could indicate a malfunction in the appliance.
12) Do not use if you have sensitive skin areas or poor circulation.
13) Disconnect power when not in use, and store in dry place.
CAUTIONS
• This unit should not be used in the following cases unless directed by a physician:
Tuberculosis, benign and malignant tumors, hemorrhages, inflammations of the skin,
phlebitis and thrombosis, open and fresh wounds, bruises, broken skin or varicose veins,
or undetermined calf pain.
• Consult your physician if you have any questions regarding the therapeutic use of this unit.
• Do not use on any unexplained pain before consulting your physician.
• Discontinue use of unit if pain increases or swelling occurs after application.
• Do not use on any part of the body that is anesthetized.
FOR HOUSEHOLD USE ONLY • Do not use on any part of the body where recent surgery was performed.
• The recommended massage time is 15-20 minutes.
• Consult your physician before use if you are pregnant.
CAUTION
MAT MAY MOVE WHEN YOU
ENTER OR EXIT BATHTUB –
EXERCISE CAUTION
Reset
Test
HOW TO USE BATH MAT AND MOTOR HOUSING HOW TO USE REMOTE CONTROL
1) Remove bath mat, motor housing and air hose from packaging. Do not fill tub first. 1) Find the remote control and carefully remove it from its wrapping.
2) Insert one end of the air hose into the female receptacle on one end of the mat. Press 2) Remove battery cover. Insert 2 AAA batteries (not included) following diagram engraved
in firmly. inside the battery enclosure. Carefully replace battery cover and make sure O ring is intact.
3) Before filling bathtub, place mat in tub with hose end toward the front of tub. Press mat
3) Your remote control has an On/Off button and a Mode button.
firmly down to engage suction cups on bottom of mat. Suction cups may lose grip on
4) Aim the remote control at the top front of the motor housing. If the remote does not work,
textured surfaces or tubs with some dirt buildup. Clean area and moisten suction cups to
check that the batteries in the remote are fresh and making good contact. Press the On/
increase suction cup grip.
Off button, and the unit is on the low setting. By repeatedly pressing the mode button the
FOR TEXTURED TUB SURFACES:
speed goes to medium and then high. Press again and the setting goes back to low.
IF CUPS DO NOT ADHERE AFTER WETTING AND PRESSING FIRMLY, THEN PROCEED
WITH CAUTION WHEN SITTING ON THE MAT. YOUR BODY WEIGHT WILL KEEP MAT
HOW TO USE FOOT ROLLERS
POSITIONED DOWN IN TUB FOR USE.
4) Place motor housing on the floor conveniently between the bathtub and electrical outlet. This model comes with foot rollers that can be used to massage the soles of your feet.
Never place the motor housing where it can fall into the tub. Have the motor housing face
1) Snap in foot rollers at the end of the mat where the hose connects. Note position in
the user in the tub, as the infrared remote control needs to be aimed by the user toward
picture in "Get to Know your Body Benefits Thermal Spa Bath Mat" section.
the motor housing.
2) These are adjustable foot rollers. Once they are locked in, they can be adjusted to your
5) Plug motor housing into 120 V AC outlet. See ALCI operating instructions to familiarize
personal needs.
yourself with its ALCI and function.
6) Insert the other end of the air hose into the motor housing.
HOW TO USE NECK MASSAGER
7) Press the remote's On/Off button; motor will run on the low setting. Try other settings to
become familiar with the unit's operation. (See "How To Use Remote Control.") 1) Remove battery cover by removing screw on back side of telescopic neck pillow.
8) Now fill the bathtub with the amount and temperature of bath water desired. Turn on unit 2) Insert 4 AAA batteries (not included) following the diagram engraved inside the battery
to desired setting.
compartment. Carefully replace cover and make sure "O" ring is intact.
9) Exercise extra caution getting into and out of the bathtub.
3) Push slide switch to the On position.
10) The bath mat is designed to maintain the temperature of the water. However, as the
4) To activate neck massage, gently apply pressure to the padded neck pillow.
overall temperature of water decreases, so will the bath mat's ability to maintain the
5) Adjust pillow height by using two hands to raise or lower neck pillow.
warm temperature.
6) To deactivate massage, push slide switch on back of pillow to Off position.
11) Use of salts and oils is acceptable with your bath mat massager. Please clean the bath mat
with fresh tap water before storing. Also note that your additions of salts or oil may make
tub and bath mat surfaces slippery.
12) After use, be sure you are dry before unplugging power unit.
13) To store, drain all water from the bath mat sections by turning gently over in the bathtub.
Disconnect the air hose from the power unit and drain air hose into tub as well. After all
free water has dripped into the tub, gently wipe any wet surfaces with a clean dry towel
before storing.
14) Dry the remote control after use. Avoid submerging or having control float on water for long
periods of time.
RECOMMENDED MASSAGING TIMES
Massage should generally last only 15-20 minutes.
The Body Benefits® Thermal Spa Bath Mat can help you relax, relieve tension and soothe minor
muscular aches and pains. Consult your physician or physical therapist for recommendations
regarding bath mat, including water temperature and duration and frequency of use.
Caution: Read safety rules and operating instructions carefully. This product is intended for
indoor use in permanent tubs. Do not use outdoors or in inflatable tubs or pools.