Download Print this page
Conair Facial Steamer Instruction Booklet

Conair Facial Steamer Instruction Booklet

Moisturizing mist micro dermabrasion system

Advertisement

IMPORTANT SAFETY
near children or by individuals with certain
disabilities.
INSTRUCTIONS
3. Use this appliance only for its intended
purpose as described in the manual. Do
When using electrical appliances, especially
not use attachments not recommended by
when children are present, basic safety
the manufacturer.
precautions should always be followed,
4. Never operate this appliance if it has a
including the following:
damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged,
READ ALL
or dropped into water. Return the appliance to
a service center for examination and repair.
INSTRUCTIONS
5. Keep the cord away from heated surfaces.
BEFORE USING
Do not wrap the cord around the appliance.
6. To avoid burning, do not pick up the unit
KEEP AWAY FROM WATER
while water is hot since water can spill out.
7. Never block the air openings of the
DANGER
appliance or place it on a soft surface, such
as a bed or couch, where the air openings
To reduce the risk of electrocution:
may be blocked. Keep the air openings free
of lint, hair, and other debris.
1. Always unplug this appliance immediately
after using.
8. Never use while sleeping.
2. Do not use while bathing.
9. Never drop or insert any object into any
opening or hose.
3. Do not place or store appliance where it
10. Do not use outdoors or operate where
can fall or be pulled into a tub or sink.
aerosol (spray) products are being used or
4. Do not place in or drop into water or
where oxygen is being administered.
other liquid.
11. Do not use an extension cord with
5. Do not reach for an appliance that has
this appliance.
fallen into water or other liquid. Unplug
12. Unplug this appliance before filling. Fill
immediately.
reservoir with tap water only. Do not overfill.
WARNING
To reduce the
13. Use The Microdermabrasion Facial Spa
risk of burns, electrocution, fire, or injury to
only on a level surface.
persons:
14. Do not use additives.
15. Never place face close to facial steamer
1. An appliance should never be left unattended
in one position as this may cause scalding.
when plugged in.
16. To avoid burning, do not touch after
2. This product is not to be used by, on, or
plugging in water reservoir unit.
17. Do not mix old and new batteries. Do
This product should not be used in the
not mix alkaline, standard (carbon-zinc), or
following cases:
rechargeable (nickel cadmium) batteries.
Tuberculosis, benign and malignant tumors,
18. Do not use the spa without the mask.
inflammations of the skin, phlebitis and
thrombosis, open and fresh wounds, bruises,
19. Do not place hand in the base.
broken skin or varicose veins.
20. Do not touch steam as it comes out of
INSTRUCTIONS FOR USING
the base.
YOUR MICRODERMABRASION
21. Do not move or pick up the unit until the
water cools.
SPA
SAVE THESE
Before beginning, cleanse your face, following
your daily care routine. Lightly pat your
INSTRUCTIONS
favorite moisturizer or eye cream around the
eye area.
USING YOUR FACIAL
OPERATING
STEAMING UNIT
INSTRUCTIONS
• Your Facial Spa includes two detachable
This appliance has a polarized plug (one
cones:
blade is wider than the other). As a safety
1. Facial Mask: Use for facial cleaning.
feature, this plug will fit in a polarized outlet
2. Sinus Cone: Use for concentrated
only one way. If the plug does not fit fully in
steam to assist in respiratory therapy.
the outlet, reverse plug. If it still does not fit,
Place your nose in the sinus cone with
contact a qualified electrician. Do not attempt
forehead touching curved rim. Relax as
to defeat this safety feature.
soothing mist promotes easier breathing,
• The Microdermabrasion unit operates on 2
however, do not use as room humidifier.
"AA" batteries. For battery
• Turn facial mask or sinus cone counter-
insertion, gently pull down
clockwise and lift away
lower cap and insert
from base.
batteries.
• Fill the water cylinder
If you have any skin
with warm tap water. Pour
condition, sensitivity to
water into the reservoir
heat, or other health issues
and plug it into a 120 volt
or questions, including those relating to use
AC household outlet. (See
of this product while undergoing any
Figure 1)
treatments or taking any medications, please
consult with a physician before use.
• Place facial mask or
sinus cone over unit. Lock
by aligning bumps on
facial mask with slots
over water reservoir and
turn clockwise. (See
Figure 2)
Figure 2
• Press "ON/OFF" button to turn unit on.
• When the power is on, the ready indicator
light will flash for 3 minutes as the water is
preheating.
• When the indicator light has stopped
flashing and is steady, you may use the
Facial Spa. Unit will automatically shut off
after 45 minutes.
• FOR A TIMED TREATMENT, the timer
control can be set from 3 to 15 minutes by
rotating the knob to desired time.
• Press the timer start button and the timer
indicator light will go on.
• The unit will shut off and a buzzer will
sound to indicate that preset time has expired.
NOTE: One fill provides between 10-30
minutes of soothing mist. If the facial spa
should run out of water, shut off
immediately, then begin your facial again.
• Clean your face and neck
• Allow approximately 3 to 4 minutes for
steam mist to develop, then place your face
gently against the rim of the facial mask or
sinus cone. To avoid burning, do not pick
up the unit while water is hot since water
will spill out.
• If more steam is desired, place a towel
Figure 1
over your head that so it covers the mask
and sides of the steamer.
• Close your eyes and relax as the soothing
mist begins deep cleansing action.
• Remove your face occasionally and blot
with a cool, damp towel. Steam for a
minimum of 5 minutes, but no longer than
30 minutes.
• Immediately after steaming, rinse your
face with cool water.
INSTRUCTIONS FOR USING
YOUR MICRODERMABRASION
TOOL
• Snap the exfoliating brush attachment
onto the unit, making sure it is securely
attached.
• Apply a generous amount of your favorite
exfoliating cream to your face.
• At the speed of your choice, massage the
cleanser on your face in a circular motion,
making sure not to exceed two minutes.
• Use for 10 second intervals per area
beginning with the forehead; avoiding the
eye area, move downwards toward the
cheek and nose area then to your chin area.
This step exfoliates, thoroughly cleans and
removes dulled skin cells. Rinse face and
pat dry. Next apply cool water or your
favorite astringent to close pores and seal
in moisture.
• Now you are ready to apply your favorite
moisturizing lotion by using the sponge
applicator. Dot your forehead, cheeks, nose
and chin with a generous amount of mois-
turizer and smooth the cream into your
skin. Apply light to medium pressure and
use upward, circular strokes. After just one
personal facial with the Microdermabrasion
Facial Spa you'll find your skin looking
fresher and healthier.

Advertisement

loading

Summary of Contents for Conair Facial Steamer

  • Page 1 14. Do not use additives. 15. Never place face close to facial steamer 1. An appliance should never be left unattended in one position as this may cause scalding. when plugged in.
  • Page 2: Pampering Tips For Delicate Areas

    • Do not attempt to repair the appliance LIMITED ONE YEAR WARRANTY WARNING: Conair will repair or replace (at our option) your unit free of charge for 12 months from IF YOU THINK THE the date of purchase if the appliance is POWER IS OFF defective in workmanship or materials.

This manual is also suitable for:

Mdf2