Advertisement
Procedure B
1.
On the C-Stat programmable stat, Press ENTER twice
2.
Press '-' or '+' to select SETUP
3.
Press ENTER
4.
Press '-' or '+' to select SET UP Z-WAVE
5.
Press ENTER
6.
Press '-' or '+' to select NETWORK RESET
7.
Press ENTER
8.
Press ENTER again to confirm and NETWORK RESET
COMPLETE will appear on the display
9.
Press BACK to go back to SET UP Z-WAVE
10. Press ENTER
11.
Press '-' or '+' to select EXCLUDE NODE / RECEIVER
12. Press ENTER
13. Go to the Powered ASR-ZW receiver, press and hold the
network button
14. EXCLUDING will appear on the display of the C-Stat
15. When completed NODE / EXCLUDED will appear on the
display.
16. The red network light on the ASR-ZW will start flashing
17. Once the red light is flashing follow Procedure A on page
11
12
Advertisement
