Brother QL-500 Software Installation Manual page 8

Installing The Software And Printer Driver (Mac OS
This section explains how to install P-touch Editor 5.0, Fonts, Auto Format Templates,
Clip Art, and the printer driver. After the driver is installed the driver configuration is
explained.
• Until the driver installation is completed, do not connect the machine to your Macintosh
Make sure the USB cable is not connected until you are instructed to connect it.
• You must be logged on as a user with administrator privileges to install this software.
Below is the example for Mac OS
Read "XXX" as your printer name.
1
Start up your Macintosh
drive.
Double click the "QL_Series" (CD-ROM) icon.
2
Click [Mac OS X] folder and double click [QL-XXX Driver.pkg].
Follow the on-screen instructions.
3
After the installation is completed and the
screen shown right is displayed, click
[Close].
The installation of the printer driver is
completed.
Next, install P-touch Editor 5.0.
4
Double click [P-touch Editor 5.0 Installer.mpkg] in [Mac OS X] folder.
The P-touch Editor 5.0 Installer starts up. Follow the on-screen instructions.
5
When the installation is completed and the
message "Click Restart to finish installing
the software." is displayed, click [Restart].
The Macintosh
The installation of software is completed.
®
X 10.5.7. In the following steps, you will see QL-XXX.
®
, and insert the CD-ROM into the CD-ROM
®
is restarted.
®
)
®
.
Mac Mac
7