Location Of Controls - Panasonic AG-VP310 Operating Instructions Manual

Location of Controls (continued)
Rear View of DECK
AC Power Plug
• While plugged into an AC outlet,
this DECK consumes 0.85 W of
electrical power in off mode.
Component Video Output
Connector (Y, P
(DVD Only)
p. 13
Optical Digital Audio
Output Connector
(DVD Only)
p. 15
S-Video Out Connector
(DVD Only)
pp. 10, 13
The following table shows the status of the output jacks when in VCR or DVD mode.
VCR
DVD
• PROG functions on the remote are not available when using Component Video Output and
Note
S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press PROG.
To enjoy PROGRESSIVE SCAN video
(1). Connect Component Video Output to the component video input terminals of a television.
(See p. 13.)
(2). When PROGRESSIVE OUT is set to "ON" in the DVD Main Menu (p. 55), a Progressive
Scan signal is output from the Component Video Output Connector .
Notes
• The screen may shift off-center when using progressive output. Please adjust the screen
position if this occurs. (Refer to your TV manual.)
• If the television is not progressive compatible, a progressive scan picture is not available.
Connect the Video Output or S-Video Output connector (see p. 12, 13) and
set PROGRESSIVE OUT to "OFF" in the DVD Main Menu. (See p. 55.)
10
Bold:
Bold Italic : VCR and DVD Functions
, P )
B R
Audio Output 2
Connector (L/R)
p. 13
Video Output
Audio Out 1
Audio Out 2
YES
YES
VCR Function
VHF/UHF Antenna Output Terminal
p.12
VHF/UHF Antenna Input Terminal
p. 12
Video Output
Video Input
Connector
Connector
p. 12
p. 35
• •
Audio Output 1
Connector (L/R)
p. 12
Component
Video Output
N/A
Italic : DVD Function
•
Audio Input
Connector (L/R)
p. 35
S-VIDEO OUT
N/A
YES