Initial Setup For Basic Connections (Ready To Play) - Panasonic AG-VP310 Operating Instructions Manual

Initial Setup for Basic Connections (Ready to Play)

Before doing Initial Setup
1
Turn TV on.
2
See connections
<RF Coaxial Cable Connection>
Set TV to channel 3.
<AV Cable Connection>
Set TV to VIDEO.
[DECK ➛ ➛ ➛ ➛ ➛ TV]
3
• Go to "Initial Setup (Ready to Play)." (See below.)
[Cable Box ➛ ➛ ➛ ➛ ➛ DECK ➛ ➛ ➛ ➛ ➛ TV], [DSS ➛ ➛ ➛ ➛ ➛ DECK ➛ ➛ ➛ ➛ ➛ TV]
• Turn on Cable Box and set it to your Public Broadcasting Station (PBS) channel
in your time zone.
• If you use a DSS Receiver, it must be turned off.
Initial Setup (Ready to Play)
1
Press VCR on remote for VCR mode.
2
Plug DECK Power Cord into AC wall outlet. DECK comes on and auto channel
and clock set starts.
• If screen below does not appear, check DECK - TV connection and, if TV is tuned to
channel 3, try switching it to channel 4.
• To change VCR's output channel, please see "VCR's Output Channel" on page 19.
Plug VCR Power plug
into an AC wall outlet.
CH AUTO SET PROCEEDING
CANCEL : STOP
AUTO CLOCK SET
CANCEL : STOP
16
a
RF Coaxial Cable Connection and
• Function buttons are void during Initial Setup.
• To eject a tape during Auto Set, press EJECT on remote
PROCEEDING
• If Auto Clock Set takes more than 30 minutes,
b
Notes
or STOP/EJECT twice on DECK.
Then make settings manually. (See p. 18.)
press STOP and perform settings manually. (See p. 18.)
AV Cable Connection on page 12.
Continued on next page...