Error Message - Panasonic Toughbook CF-T8EWATZJM Reference Manual

Error Message

Follow the instructions below when an error code or message appears. If the problem persists or if the error code/message
displayed is not shown here, contact your technical support office.
Error Message
Bad System CMOS
System CMOS Checksum Error
Invalid Year. System date restored to
01/01/2010
Error
Hard disk access is prohibited by
"Hard Disk Lock". Please enter the
Setup Utility and change the values
correctly to permit access.
Press <F2> to enter setup
Reboot and Select proper Boot
device or Insert Boot Media in
selected Boot device and press a key
Disk Error
Press any key to restart
Extended RAM Module Failed
Standard RAM Failed
An error has occurred in the memory of system settings. This occurs when the
memory content is changed by an unexpected program operation, etc.
Start the Setup Utility and return the settings to the default values, and then
change the settings as necessary.
If the problem persists, the internal clock battery may need to be replaced. Con-
tact your technical support office.
The date and time settings are not correct.
Start the Setup Utility and set the correct date and time.
If the problem persists, the internal clock battery may need to be replaced. Con-
tact your technical support office.
The hard disk access is prohibited.
Start the Setup Utility and select [Disabled] in [Hard Disk Lock] in the [Security] menu.
Write down the error details and press F2 or Del to start the Setup Utility.
Change the settings if necessary.
The operating system is not installed in the floppy disk or the hard disk that you are
going to boot from.
If using a floppy disk, change the disk to the one you can use for boot.
If using the hard disk, check if the hard disk is recognized in [Information] menu of
the Setup Utility. If the hard disk is recognized, perform the reinstallation (⇒Oper-
ating Instructions "Reinstalling Software"). If not, contact your technical support
office.
If a device is connected to the USB port, disconnect the device, or set [Legacy
USB Support] to [Disabled] in the [Advanced] menu of the Setup Utility.
The RAM module is not inserted correctly. Turn off the computer, and confirm that
the RAM module conforms to the recommended module, and reinsert it.
The cooling fan does not work correctly. Contact your technical support office.
Solution
120