Panasonic Toughbook CF-T5MWETABM Operating Instructions Manual page 30

Troubleshooting (Basic)/Error Code/Message
Battery
The battery indicator is
blinking.
The battery indicator is
flashing.
Touch Pad / Touchscreen
The cursor does not work.
Cannot input using the
touch pad.
Cannot input using the
touchscreen.
Cannot point the correct posi-
tion using the included stylus.
Reference Manual
The Reference Manual is not
displayed.
Others
[System Restore] does not
appear by pressing F8.
No response.
The PC information viewer
startup is slow.
30
If blinking red:
Quickly save your data and power off your computer. Remove the battery pack and dis-
connect the AC adaptor, then connect them again. If the problem persists, contact your
technical support office. The battery pack or charging circuit may be defective.
If blinking orange:
• Battery cannot be recharged temporarily because the internal temperature of the bat-
tery pack is outside the acceptable temperature range for recharging. Your computer
can be used normally in this state. Once the range requirement is satisfied, charging
begins automatically.
• Software applications and peripheral devices (USB devices, etc.) are consuming too
much power. Exit the software applications currently running. Once the range require-
ment is satisfied, charging begins automatically.
The battery is recharging.
If [Battery Charging Indicator] in [Main] menu of the Setup Utility is set to [Flashing],
the indicator will alternately become lighter and darker.
When using the external mouse, connect it correctly.
Restart the computer by using the keyboard.
Press and press three times, and press
If the computer does not respond to keyboard commands, read "No response" (
Set [Touch Pad] to [Enable] in the [Main] menu of the Setup Utility.
The drivers for some mice may disable the touch pad. Check your mouse's operating instructions.
When mouse drivers are installed (i.e. IntelliMouse), the touchscreen does not work.
Reinstall the touchscreen driver.
Perform the touchscreen calibration (
Install Adobe Reader.
A Log on to Windows as an administrator.
B Click (Start) and input "c:\util\reader\AdbeRdr70_enu_full.exe" in [Start Search]
Enter .
then press
C Update Adobe Reader to its latest version.
If your computer is connected to the internet, start up Adobe Reader and click [Help] -
[Check for updates now].
The restoration program does not run after Windows Anytime Upgrade is executed.
For further information, access the following web site:
https://eww.pavc.panasonic.co.jp/pc/itn/support/vistainfo.html
Ctrl + Shift + Esc to open Task Manager and close the software application that
Press
is not responding.
An input screen (e.g., password input screen at startup) may be hidden behind another
Alt + Tab to check.
window. Press
Slide the switch for four seconds or longer to shut down the computer, and then slide the
power switch to turn it on. If the application program does not work normally, uninstall and
reinstall the program. To uninstall, click
It may take a minute or longer to start up depending on the network environment.
to select [Restart] and press
page 15).
(Start) - [Control Panel] - [Uninstall a program].
Enter .
below).