Table of Contents
Advertisement
4
Open the display.
A Press and hold the latch (B) located at the front.
B Lift open the display.
Do not open the display wider than necessary (140° or more), and do
not apply excessive pressure to the LCD. Do not open or close the
computer holding the edge of the LCD segment. Hold the C (below)
segment to open or close the computer.
5
Connect your computer to a power outlet.
Be sure the AC adaptor is connected until completing the first-time use
operation.
The battery pack will be charged automatically.
Charging Time: Approx. 5 hours (Power off), Approx. 7 hours (Power on)
(Varies depending on the usage conditions.)
When using the computer for the first time, do not connect any peripheral
device except the battery pack and AC adaptor to the computer.
CAUTION
Handling the AC adaptor
Do not subject the AC adaptor to any strong impact.
Using the AC adaptor after a strong impact such as being dropped may result in
electrocution, short circuit, or fire.
Use only the specified AC adaptor with your computer. Using an AC adaptor
other than the one supplied might damage the battery and/or the computer.
Problems such as sudden voltage drops may arise during periods of thunder
and lightning. Since this could adversely affect your computer, an uninterrupt-
ible power source (UPS) is highly recommended unless running from the battery
pack alone.
6
Turn your computer on.
Slide the power switch
the power indicator
CAUTION
Do not slide the power switch and hold it for more than four seconds; this will
cause the power to be turned off forcibly.
Do not slide the power switch repeatedly.
Do not press any keys or touch the touch pad or touchscreen until [Windows XP
Professional Setup] is displayed.
Do not change the Setup Utility until completing step 7. If you do so, Windows
setup may not operate properly.
and hold it for approximately one second until
turns on before releasing it.
15
Advertisement
Table of Contents
